PDF Workshop Manual STILL STED Forklift CITI one - 951 KB

This workshop manual provides complete service and repair information for the STILL CITI one forklift.

It includes detailed instructions for disassembly, repair, and reassembly of all major components.

Technicians can rely on this manual for specifications, troubleshooting charts, and system diagrams.

It is the ultimate guide for maintaining the performance and reliability of your STILL forklift.

DOWNLOAD PDF FULL MANUAL

PDF Viewer

Viewer loads when you scroll here

PDF viewer loading area

Text Preview from This Manual

The text below was extracted from the visible preview pages to help you confirm the manual contents before download.

--- Page 1 ---
0110 2350

11308012006 EN - 01/2020

--- Page 3 ---
The CiTi could be in standby mode. Restart after
resetting the emergency stop switch
            after 10 minutes of inactivity, CiTi au-
tomatically switches to standby mode
– To restart CiTi, simply press on the emergen-
  cy stop button and reset it.


The CiTi has almost no power left and must be
charged. For further information on charging the
CiTi battery, please refer to the "Charging the
battery" chapter in the "Battery equipment"
sheet.
Reminder of the battery level information:
  100 % (10 bars in the battery) = battery OK
  20 % (2 bars) = flashing + danger sign: speed
  = 50 %


  -6                                            11308012006 EN - 01/2020

--- Page 4 ---
Repair the cables or replace the traction motor    End of procedure
    Connect the power supply correctly             End of procedure


   Check if the lifting motor cables are OK          Go to step 2       Go to step 6
       Connector (2X1) disconnected?                 Go to step 7       Go to step 3
           Replace the lifting motor                 Go to step 4
              Fault still present?                   Go to step 5     End of procedure
            Replace the controller                 End of procedure
 Repair the cables or replace the lifting motor    End of procedure
    Connect the power supply correctly             End of procedure


                        11308012006 EN - 01/2020                                       -17

--- Page 5 ---
Designation                 Comment                       Message on the display
                             100% = full charge                   100% = battery ok
1     Battery level   10% = the battery must be charged       20% = flashing + symbol (7):
                        0% = battery empty, traction off             speed = 50%


-28                                11308012006 EN - 01/2020

View the complete manual on HeyDownloads →